Just bought a used one without manual.How do l set the seat memory and garage opener?

Set ur seat position, mirrors, etc. to u desired position. Then hit the ''M'' button (for Memory), & the hit 1. If u have another driver, have them set everything they like, hit ''M'' & 2, & their positions r remembered. Thereafter, just hit 1 or 2 (depending on which driver is driving), & that Memory position will be reset. It is safer to do this before starting to drive, as extremely different sized drivers could get into an awkward positions if they hit the wrong button for them!

Dr. C is correct, but u need to HOLD the M button down & hit the 1 or 2 button at the same time.

and to program the homelink, push & hold (about 15 seconds) the button that u want to use for the garage. the red light will stay on, then start to blink slowly. take ur garage door opener & push the button, if the homelink sees & takes the signal, the red light will blink fast.

if it doesnt take the code, it may not be compatable (like it was for me).

good luck!